Mycest Potentiometer Module

Potentiometer Module is a part of Blockduino Kit. It was design to simplify the wiring connection between microntroller and the module. It have three wire connection which is Signal (S), Vcc (V) and Ground (G). The signal pin should be connected to Arduino analog pin (A0-A7), Vcc to +5v / +3.3v (ESP) and Ground. This Potentiometer Module use resistor 10K, the signal will send (0-5v) to Arduino pin.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: